Skip to Content

Measurement model · research

AI belongs at the measurement signal layer.

We research an AI model within the sensor to analyse signal patterns alongside physical calculations, aiming to produce readings with confidence assessments.

Position
Inside the sensor, before a reading is formed
Stage
Research: model design and simulation tests
Next
Collect real signals
Target output
Readings with confidence assessments

Our view

Reading confidence depends on measurement conditions

  • How readings are formed

    Sensors calculate readings from measurement signals using physical formulas. Those formulas assume particular measurement conditions.

  • Conditions can change

    Bubbles, particles, temperature or installation may depart from those conditions. A reading alone often cannot show whether the conditions hold.

  • Signals carry more information

    A reading is one result calculated from a signal. We research learned models to analyse the richer signal patterns alongside physical calculations and assess reading confidence.

We therefore see greater scope for AI before a reading is formed; planned cloud analysis will build on that layer’s outputs.

Scope

What the model aims to do, and its limits

  • Research aim

    Research aims

    • Analyse signal patterns alongside physical calculations.

    • Support reading assessment under complex conditions.

    • Produce readings with confidence assessments.

  • Boundaries

    Limits

    • Do not replace physical formulas.

    • Not metrological certification; no replacement for calibration.

    • No accuracy figure is published before independent verification.

Validation

Research conclusions need real-data validation

Test on simulated data, then compare real signals against independent reference readings. Return to design if the results do not hold.

  1. In progress

    Model design and simulation tests

    Design the model framework and test it on simulated data; a first round of tests is complete.

  2. Next

    Collection of real signals

    Record raw signals on a test pipe with independent reference readings. Collection has not started.

  3. Later

    Validation on real data

    Compare with conventional calculations against independent references; return to design if the results do not hold.

  4. Later

    Embedding in the sensor

    Compress the validated model to run on the sensor processor.